Signal Configuration

In main-window of GUI, Basic Configuration → Signal Config

 

 

 

 

 

1. Radio Frequency

It can be freely set for testing purposes.
For settings for mass production, refer to each country’s regulatory/standards(ex, FCC, KC).

 

Parameter	Default [MHz]	Range [MHz]	Description
Chirp Start Frequency	24,015	22,500~27,500	Highest frequency of chirp signal, ex)24050 MHz in KC
Chirp Cutoff Frequency	24,245	22,500~27,500	Lowest frequency of chirp signal, ex) 24250 MHz in KC
CW Frequency	24,015	22,500~27,500	Only effective when “Waveform Mode” is set as CW.

 

 

 

 

 

 

2. Radio Path

Options for selecting receiving and transmitting antenna configuration

 

Parameter	Default	Range	Description
Tx Config	Enable	Enable
		Disable
Rx Config	All On	All On	1T2R test
		RX1	1T1R test
		RX2	1T1R test
		All Off

Note. in case of 1T1R,SoC, sett  one of  “RX1” and “All Off” .  

 

 

 

 

 

 

3. Radio Gain

Gain controls are applied to both transmitter and receiver to adjust the whole link budget to work in different scenarios.

 

Parameter	Default/Recommend	Range	Description
Tx Gain	LV2	LV1(High)	~11 dBm
		LV2(Rec)	~09 dBm, Recommendation
		LV3(Med)	~07 dBm
		LV4(Low)	~05 dBm
		LV5(XLow)	~03 dBm
Rx Gain	LV1	LV1(Rec)	~ 27 dB
		LV2(Med)	~ 24 dB
		LV3(Low)	~ 20 dB