AT Commands For UIM Hotswap
| No | Command | Description |
| L2401 | AT+UIMHOTSWAPON | Set UIM hotswap function on |
| L2402 | AT+UIMHOTSWAPLEVEL | Set UIM card detection level |
L2401 AT+UIMHOTSWAPON Set UIM Hotswap Function On
| R) AT+UIMHOTSWAPON? |
+UIMHOTSWAPON: <onoff> OK |
| W) AT+UIMHOTSWAPON=<onoff> |
OK or ERROR |
| <onoff> |
0 The UIM hotswap function is disabled 1 The UIM hotswap function is enabled |
| Example |
AT+UIMHOTSWAPON? +UIMHOTSWAPON: 0 OK AT+UIMHOTSWAPON=1 OK |
NOTE
Module reset to take effect
L2402 AT+UIMHOTSWAPLEVEL Set UIM Card Detection Level
| R) AT+UIMHOTSWAPLEVEL? |
+UIMHOTSWAPLEVEL: <level> OK |
| W) AT+UIMHOTSWAPLEVEL=<level> |
OK or ERROR |
| <level> |
0 ACTIVE LOW 1 ACTIVE HIGH |
| Example |
AT+UIMHOTSWAPLEVEL? +UIMHOTSWAPLEVEL: 0 OK AT+UIMHOTSWAPLEVEL=1 OK |
NOTE
Module reset to take effect
Set UIM card detection level to active low. //Refer to the used SIM card holder, usually it’s a “normal open kind” one. The default value 1
Radar Sensor SoC & Module
WiFi IoT Module
5G/LTE/CAT-M1/NB-IoT
WiSUN/HaLow/Thread Module
