SoC Register Setting
The following process allows you to extract registers and their settings for various radar SoCs.
The EVB is applied to 1T2R SoC, but Demo GUI can be used commonly for both 1T1R and 1T2R SoCs.
1. Configure
Signal Config | Waveform Config | Output Config |
![]() |
![]() |
![]() |
Note. in case of 1T1R, set one of “RX1” and “All Off” in Signal Config → Rx Config.
RX Config | Supported SoC | |
All On | 1T2R | |
RX1 | 1T1R, 1T2R | |
RX2 | 1T2R | |
All Off | 1T1R, 1T2R |
2. Review the configuration
Menu. File → Config. Overview
Configuring in the state of opening this window, you can review the configuring results of each setting -by-setting.
3. Save the configuration to a file
The result registers and its values can be saved as a file and and you can use this file to set SoC.
Menu | File Format | Description | |
File → Save Config. | *.ini | ||
File → Save Create Firmware Config. | *.txt |