SIM7600/SIM7800 Series – EVB & TE-Kit Manual
SIM7600E 개발자보드(EVB KIT)는 Base Board + TEKIT(SIM7600 IF Board) + AC/DC Adaptor + Antenna + USB Cable 로 구성되어 있다.
SIM7600을 이동통신망에 접속하기 위해 SIM Card를 별도로 구매하여 사용해야 한다.
1. SIM7600E 개발자보드 구성
 |
 |
| SIM7600 EVB 개발환경(결합상태) | SIM7600 EVB 개발환경(분해상태) |
2. SIM7600E 개발자보드 인터페이스
|
|
A: USB Interface |
Enhanced COM= AT Command Port Standard COM = Debug Port |
| B: Power Key |
Press for more than 1.5 sec, then the module will be turned on and network LED light(D401) will blink |
|
| C: Reset | Reset the module | |
| D: Power SW(S201) |
After 5V Adapter inserted, Switch on, then power LED(D201) will be solid on. |
|
| E: RF SW(S401) | ON=Flight-mode off, OFF= Flight-mode on | |
| F: TE Connector | TEKIT Connector | |
| G: TE Connector | TEKIT Connector | |
| H: SIM Holder(J202) | Main SIM Card holder | |
| I: LED for Net-light | Refer to below table | |
| J: LED for Power |
Bright: EVB Power ON, Extinct: EVB Power OFF |
|
| K: Test Point | ||
| L: Studs and Nuts | ||
| M: Direction Mark | TE Board direction mark | |
| N: LED for Status | Bright: Module runs normally Extinct: System is powered down |
|
| O: Handset Jack | (1)MIC-, (2)SPK-, (3)SPK+, (4)MIC+ | |
| P: Power Jack | 5V/2.0A DC source input | |
| Q: SIM Holder(J203) | To supports dual SIM module | |
| R: Ear-phone Jack |
3. Evaluation Board Schematics
 |
§SIM7600_TE Kit_Schematic_8PYA00-7600-TE_V1.03 | TE(Daughter Board) Schematic |
|
§SIMCOM_EVB KIT_Schematic_8PYA00-SIMCOM-EVB_V1.02 | EVB(Base Board) Schematic |
WiFi IoT Module
Bluetooth Module
5G/LTE/CAT-M1/NB-IoT
